Icom IC-746 Instruction Manual page 28

4
USING DIFFERENT OPERATING MODES
(4) Contact number menu
1
ANT
1 3 5 7 9
S
Po
20 50
ALC
SWR
1 1.5 2 3
P. AMP
1
F1 F2
Set item up/down
SET MODE ITEM AND DEFAULT CONDITION
26
CW
20 40 60
BLANK
100% VFOA
AGC
S
F
F3 F4
This menu is used to set the contact (serial) number
and count up trigger, etc.
Push [F1] or [F2] to select the set contents.
Rotate the tuning dial to set the condition.
• See below for details.
Push [MENU] 2 times to return to regular operation
(M1).
CH
F5
This item sets the numbering system used for con-
tact (serial) numbers—normal or morse cut numbers.
• Normal: does not use morse cut numbers (default).
• 190 ANO: sets 1 as A, 9 as N and Ø as O.
• 190 ANT: sets 1 as A, 9 as N and Ø as T.
• 90 NO: sets 9 as N and Ø as O.
• 90 NT: sets 9 as N and Ø as T.
This item sets the count up trigger channel.
• M1, M2, M3 or M4 can be set.
This item shows the current number for the count up
trigger channel set above.
• Rotate the tuning dial to change the number, or push
[F3]( ) for 2 sec. to reset the current number to 001.
DESCRIPTION