To Use Last Number Redial; To Use Speed Dial - NEC Dterm PSIII User Manual

3-8 Using the PSIII
NOTE
NOTE
Enter the first few letters of the last name and then press the
Step 2
Scroll key. The names matching the letters entered will display.
If you enter one character, the names that start with that character will be
displayed. If you enter two characters, names that start with those
characters will display, and so on.
If the desired name is not displayed, use the Scroll
to locate the next name and number. Continue to press the Scroll
Scroll keys until you locate the desired name.
After selecting the name, press L1 or L2* to dial the number.
Step 3
To make another selection, press END/PWR, and then repeat the steps
Step 4
above.

To Use Last Number Redial

The Dterm PSIII retains the last 20 numbers you have called.
To dial a number using this feature, do the following:
Step 1
—While the PSIII is in a standby state, press the Scroll
will display the last number dialed.
—If that is the number you wish to dial, press L1or L2*.
—If that is not the number you wish to dial, press the Scroll
scroll through the last 20 numbers dialed.
If you dial the same number several times, only the latest dialed information will be
displayed.
*Mode 2 features are only available with NEAX 2000 (Series 1900 software or later)
and NEAX 2400 (Series 7300 software or later). Zone Transceiver 5.00 software (or
later) must be used.

To Use Speed Dial

You can place a call by searching for a Speed Dial Number by entering
the number or by using the scroll key.
To Place a Call Using Speed Dial
While in a standby state, press the Scroll
Step 1
box displays (Figure 3-9).
Dterm PSIII User Guide - Revision 1
or Scroll keys
key. The PSIII
key to
key. A Speed Dial dialog
or