NEC Dterm PSIII User Manual page 50

3-36 Using the PSIII
NOTE
NOTE
NOTE
Press the FNC key to confirm.
Step 5
A setting tone will ring and then the PSIII returns to a standby state after
two seconds.
*Mode 2 features are only available with NEAX 2000 (Series 1900 software or later)
and NEAX 2400 (Series 7300 software or later). Zone Transceiver 5.00 software (or
later) must be used.
To Cancel Call Forwarding - Busy
Press FNC+3+5+1. A Call Forwarding - Busy dialog box displays
Step 6
(Figure 3-43).
Press the FNC key or 2 to reset Call Forwarding - Busy. For Mode 2*
Step 7
systems, a Call Forwarding - Busy Access Code dialog box displays
(Figure 3-44).
Type in the access code to cancel Call Forwarding - Busy.
Step 8
#3=Call Forwarding - Busy, Cancel.
Example:
Press the FNC key to enter.
Step 9
Press the FNC key to confirm.
Step 10
A setting tone will ring and then the PSIII returns to a standby state after
two seconds.
*Mode 2 features are only available with NEAX 2000 (Series 1900 software or later)
and NEAX 2400 (Series 7300 software or later). Zone Transceiver 5.00 software (or
later) must be used.
Call Forwarding - Don't Answer
This feature enables you to set the access code that is used to establish
call forwarding when you do not answer the phone.
Check with your system administrator for the list of access codes.
Dterm PSIII User Guide - Revision 1