To Disable Incoming Call Vibration Notification; Service Alarm; Service Alarm Dialog Box - NEC Dterm PSIII User Manual

Figure 3-23 Service Alarm dialog box
NOTE
Dterm PSIII User Guide - Revision 1

To Disable Incoming Call Vibration Notification

Press FNC+3+1+2.
Step 1
Select [2] Off and then press the FNC key or 2.
Step 2

Service Alarm

The Service Alarm feature alerts you if you are in an area without
service, or if the battery is running low.
To Turn On Service Alarm
Press FNC+3+1+3. A Service Alarm dialog box displays
Step 1
Service ALM
[1]On
[2]Off
For Mode 2* systems, select [1] On and then press the FNC key or 1.
Step 2
A setting tone will ring and then the PSIII returns to a standby state after
two seconds.
To Turn Off Service Alarm
Press FNC+3+1+3.
Step 1
For Mode 2* systems, press the FNC key or 1.
A setting tone will ring and then the PSIII returns to a standby state after
two seconds.
*Mode 2 features are only available with NEAX 2000 (Series 1900 software or later)
and NEAX 2400 (Series 7300 software or later). Zone Transceiver 5.00 software (or
later) must be used.
Using the PSIII 3-23
(Figure 3-23).