Execute Default Set Dialog Box - NEC Dterm PSIII User Manual

3-52 Using the PSIII
Figure 3-73 Execute Default Set dialog box
NOTE
Press the FNC key or 1. For Mode 2* systems, an Execute Default Set
Step 2
dialog box displays
Execute?
Press the FNC key to confirm. For Mode 2* systems, A Default Set
Step 3
Complete confirmation screen displays.
A setting tone will ring and then the PSIII returns to a standby state after
two seconds.
*Mode 2 features are only available with NEAX 2000 (Series 1900 software or later)
and NEAX 2400 (Series 7300 software or later). Zone Transceiver 5.00 software (or
later) must be used.
Reset All
Reset All is a maintenance function. When this feature is activated, all
settings are defaulted back to the factory values.
Functions
Call Volume
Vibration
Service ALM
CONF. Tone
Key Click
Key Light
LED Flash
Soft Key
VM Number
MSG Storage
Protect TMM
TM Reminder
Ring Volume
Speaker Ring
STN Ring
(Figure 3-73).
Default Setting
Standard
Delete all registered data
Delete all registered data
Standard
Pattern 1
Dterm PSIII User Guide - Revision 1
Off
On
On
On
On
On
- - -
Off
Off
On