Working In The 3Bm Screens - 3Ware 9650SE-2LPML User Manual

Chapter 5. 3ware BIOS Manager 2 (3BM 2) Introduction

Working in the 3BM Screens

60
The main screen (Figure 30) shows the current configuration for the
3BM
drives attached to your controller, and a list of any available drives. Unusable
and incomplete drives are also shown.
Figure 30. 3BM Main Display
You will see one or more of the following sections in the main 3BM screen:
• lists any unconfigured, independent drives (JBODs)
Available Drives
that are not associated with an array, and hot spares. If this section does
not appear, there are no available drives.
• Exportable Units lists the existing units, along with the drives contained
in each. These are the units that will be available to the operating system
when you boot your computer. If this section does not appear, no units
have been configured.
If you have more than one unit, the boot unit is the one at the top of the
list. (You can change the order by highlighting a unit and pressing the
PgUp or PgDn key.)
• lists any RAID configuration missing too many drives
Unusable Arrays
to construct the unit. For example, a RAID 5 unit with two or more drives
missing would appear in this list.
• Incomplete Drives and Others
with missing or failed drives, drives that are not usable, and drives that
were part of a unit on a 3ware 7000/8000-series controller, and contain
data that needs to be updated before your 3ware 9000 series controller can
use them. (If you want to move a unit from a 7/8000 controller to the 9000
controller, you must convert the drives first. For more information, see the
section "Moving a Unit from One Controller to Another" on page 126.)
When some of the drives are remaining from a unit, you can power down
and add the missing drives to complete the unit. To use drives that are
lists drives that are remaining from a unit
3ware Serial ATA RAID Controller User Guide