3Ware 9650SE-2LPML User Manual page 162

Chapter 9. Maintaining Units
152
scheduling is enabled, the unit will not start actively rebuilding until the
next scheduled time.
Note:
If you need to cancel a rebuild, you can do so by using the Remove Drive
link on the Maintenance page to remove the drive from the unit.
Rebuilding Units through 3BM
When a RAID unit becomes degraded, it is marked as such, and the drive(s)
that failed are marked as
Figure 63, shows an example of how a degraded RAID 5 unit appears in
3BM.
Figure 63. Degraded RAID 5 Array to be Rebuilt
You can start the rebuild of a degraded unit manually in 3BM, or you can let
the system boot and allow the rebuild to take place automatically.
To start the rebuild of a unit through 3BM
1 Reboot the system and start 3BM.
A red message box informs you that the unit is degraded, and suggests
some possible approaches. Figure 64 shows an example of a degraded-
array message.
in the 3BM screens.
Not In Use
3ware Serial ATA RAID Controller User Guide