Installing The Driver On A System That Boots From A Different Device - 3Ware 9650SE-2LPML User Manual

Installing the Driver on a System that Boots from a
Different Device
www.3ware.com
6 If the "Digital Signature Not Found" message appears, click Yes to
continue the installation.
(If there are multiple controllers in the system, you will see this message
once for each controller.)
7 Continue with the normal Windows installation at this point. There are no
instructions after installing the driver that are specific to 3ware. If you
need additional instructions, refer to the Windows 2000, Windows XP, or
Windows Server 2003 documentation supplied by Microsoft.
8 Follow the instructions under "Making Units Managed by a 3ware
Controller Available to Windows" on page 38.
If you are installing the 3ware RAID controller on a system that already has
the operating system installed on another drive, follow the instructions in this
section, depending on the version of Windows installed on your system:
• "To install the 3ware driver under Windows 2000" on page 33
• "To install the 3ware driver under Windows XP or 2003" on page 35
To install the 3ware driver under Windows 2000
When you start Windows after installing a 3ware RAID controller, Windows
recognizes it as a Plug and Play device, and brings up the Found New
Hardware Wizard. This wizard guides you through installing the 3ware
driver (see Figure 18). Note that you will see screens for the installation of
two drivers during this process.
Driver Installation Under Windows
33