Enabling And Disabling Queuing For A Unit - 3Ware 9650SE-2LPML User Manual

Enabling and Disabling Queuing for a Unit

www.3ware.com
The page refreshes, and a message at the top confirms the change you
have made.
To set the Continue on Source Error During Rebuild policy in 3BM
1 At the main 3BM screen, select the unit by highlighting it and pressing
.
Enter
An asterisk appears in the left-most column to indicate that it is selected.
2 Tab to the Maintain Unit
3 On the pop-up menu, select
4 In the Configure Disk Array
Source Error During Rebuild
5 Press to display the choices, use the
Enter
setting you want (Enabled or Disabled), and press
it.
6 Tab to the OK button and press
You return to the main 3BM screen.
7 When you are finished making changes, press
3BM.
Some drives support NCQ (Native Command Queuing), a feature that can
result in increased performance for applications that require a lot of random
access of data (usually server-type applications). This is accomplished by
causing command reordering to be done on the drive.
In order to make use of NCQ, the feature must be enabled at both the drive
and the controller. You can enable support for NCQ on a per-unit basis, as
described below.
You can see whether NCQ is supported and enabled for a particular drive in
the Drive Details window. For details, see "Drive Details window" on
page 193.
Note:
Not all drives support NCQ. If a drive does not support NCQ, the policy
setting for the controller is ignored.
button and press Enter .
Configure and press
screen, Tab to the field
.
arrow keys
Enter to select it.
F8
Setting Unit Policies
Enter .
Continue on
to select the
Enter again to choose
to save them and exit
111