Setting The Storsave Profile For A Unit - 3Ware 9650SE-2LPML User Manual

Chapter 8. Configuring Units

Setting the StorSave Profile for a Unit

112
To enable or disable queuing for a unit through 3DM
1 Choose
Management > Controller Settings
2 In the
Unit Policies
queuing by checking the box under "Queuing" for the designated unit;
disable it by unchecking the box.
The page refreshes, and a message at the top confirms the change that you
have made.
To enable or disable queuing for a unit through 3BM
1 At the main 3BM screen, select the unit by highlighting it and pressing
An asterisk appears in the left-most column to indicate that it is selected.
2 Tab to the
Maintain Unit
3 On the pop-up menu, select
4 In the
Configure Disk Array
.
Mode
5 Press to display the choices, use the
Enter
you want (Enabled or Disabled), and press
6 Tab to the OK button and press
You return to the main 3BM screen.
7 When you are finished making changes, press
3BM.
You can set the desired level of data protection versus performance for a unit
by selecting the StorSave Profile. Three profiles are provided: Protection
(maximum data protection), Performance (maximum performance, less data
protection), and Balanced (a middle ground).The default is Protection.
About StorSave Profile Levels
The three profiles automatically adjust several different factors that affect
protection and performance on a per unit basis. These are summarized in the
table below and further explained after the table.
section of the Controller Settings page, enable
button and press
Enter
and press
Configure
screen, to the field
Tab
arrow keys
Enter
Enter to select it.
3ware Serial ATA RAID Controller User Guide
from the menu bar in 3DM.
Enter
.
.
Enter
Drive Queuing
to select the setting
again to choose it.
F8 to save them and exit
.