Starting A Dishwashing Cycle; Setting The Delay Timer; Switching Off The Dishwasher - Electrolux ESL 6226 User Information

Starting a dishwashing cy-
cle
1. Check that the spray arms can turn freely.
2. Turn the water tap on fully.
3. Press the ON/OFF button.
4. Select the desired programme.
The programme indicator will illuminate.
5. Close the door. The wash programme will begin.
Interrupting or Cancelling a dish-
washing cycle
Interrupt a dishwashing cycle that is in progress if it
is absolutely necessary.
Interrupting the dishwashing pro-
gramme by opening the dishwasher door
1
Hot steam may escape when the door is
opened. There is a risk of scalding.
1. Open the door carefully. The dishwashing cycle will
stop.
2. Close the door. The cycle will continue.
Cancelling the wash programme
1. Press function buttons 2 and 3 and hold them
down.
The LED indicators of all the programme buttons
that can be selected will illuminate.
2. Release the function buttons. The wash pro-
gramme has been cancelled.
3. If you want to start a new wash programme, check
whether there is any detergent in the dispenser.

Setting the Delay Timer

Using the delay timer you can delay the start of a
dishwashing cycle for 3, 6 or 9 hours.
1. Press the ON/OFF button.
2. Press the Delay Timer button repeatedly until the
indicator next to the number of hours for which the
start of the dishwashing cycle is to be delayed
lights up, e. g. , if the cycle is to start in 6 hours.
6h
3. Select dishwashing cycle.
The LED indicator for the programme selected and
the indicator next to the number of hours will light
up.
4. Close the door.
The dishwashing cycle will start automatically follow-
ing a countdown of the hours set.
To change the time delay:
As long as the cycle has not yet started, you can still
change the setting by pressing the DELAY TIMER
button.
Cancelling the delay timer:
Press the DELAY TIMER button repeatedly until none
of the three time displays is lit. The selected dish-
washing cycle will begin immediately.
To change a dishwashing cycle
As long as the cycle has not yet started, you can still
change the dishwashing cycle. First cancel the dish-
washing cycle, then re-set the time delay, lastly se-
lect the new dishwashing cycle.
Switching Off the dish-
washer
If the acoustic signal has been enabled, a continuous
tone will sound for 15 seconds at the end of the dish-
washing cycle.
If the dishwasher door is not opened, the acoustic
signal sounds again after 3 and 6 minutes.
1
Carefully open the door. Hot steam may es-
cape.
• Hot dishes are sensitive to knocks. Therefore leave
the dishes to cool for about 15 minutes before re-
moving them. You also get a better drying result.
• Dishes dry more quickly if you open the door for a
moment after the cycle has ended and then leave it
slightly open.
1.Press the ON/OFF button. All display indicators will
go out.
2.Turn off the water tap.
Removing the Dishes
3
It is normal for the inner door and the dispens-
ers to be damp.
• Empty the lower basket first, then the upper bas-
ket. This way you avoid dripping water from the
upper basket onto dishes in the lower basket.
21