Starting A Dishwashing Cycle; Setting The Delay Timer; Switching Off The Dishwasher - Electrolux ESI 6231 User Information

Starting a dishwashing
cycle
1. Check that the spray arms can turn freely.
2. Turn the water tap on fully.
3. Close the door.
4. Press the ON/OFF button.
5. Select the desired cycle.
The programme display lights up. The selected cy-
cle will begin after approximately 3 seconds.
Interrupting or aborting a dish-
washing cycle
Only interrupt a dishwashing cycle that is in progress
if it is absolutely necessary.
Interrupting the dishwashing pro-
gramme by opening the dishwasher door
1
Hot steam may escape when the door is
opened. There is a risk of scalding.
1. Open the door carefully. The dishwashing cycle will
stop.
2. Close the door. The cycle will continue.
Aborting the dishwashing cycle
1. Press function buttons 2 and 3 and keep them
pressed.
The programme display for the current cycle will
flash for several seconds and then go out.
2. Release the function buttons. The dishwashing cy-
cle has been cancelled.
3. If you want to start a new cycle, check whether
there is any detergent in the dispenser.
3
Turning off the dishwasher will only interrupt a
selected dishwashing cycle, not cancel it. The
cycle will recommence after turning the dish-
washer back on again.

Setting the Delay Timer

Using the delay timer you can delay the start of a
dishwashing cycle for 3, 6 or 9 hours.
1. Press the ON/OFF button.
2. Press the Delay Timer button repeatedly until the
indicator next to the number of hours for which the
start of the dishwashing cycle is to be delayed
lights up, e. g. , if the cycle is to start in 6 hours.
6h
3. Select dishwashing cycle.
The LED indicator for the programme selected and
the indicator next to the number of hours will light
up.
The dishwashing cycle will start automatically follow-
ing a countdown of the hours set.
20
To change the time delay:
As long as the cycle has not yet started, you can still
change the setting by pressing the DELAY TIMER
button.
Cancelling the delay timer:
Press the DELAY TIMER button repeatedly until none
of the three time displays is lit. The selected dish-
washing cycle will begin immediately.
To change a dishwashing cycle
As long as the cycle has not yet started, you can still
change the dishwashing cycle. First abort the dish-
washing cycle, then re-set the time delay, lastly se-
lect the new dishwashing cycle.
Switching off the dish-
washer
Do not switch off the dishwasher until the indicator
for the end of the dishwasher cycle is illuminated in
the cycle progress display.
With some dishwashing cycles, the drying fan con-
tinues to run even after the end of the cycle.
1.Press the ON/OFF button. All display indicators will
go out.
2.Turn off the water tap.
1
Carefully open the door. Hot steam may es-
cape.
• Hot dishes are sensitive to knocks. Therefore leave
the dishes to cool for about 15 minutes before re-
moving them. You also get a better drying result.
• Dishes dry more quickly if you open the door for a
moment after the cycle has ended and then leave it
slightly open.
Removing the dishes
3
It is normal for the inner door and the dispens-
ers to be damp.
• Empty the lower basket first, then the upper bas-
ket. This way you avoid dripping water from the
upper basket onto dishes in the lower basket.