Table of Contents
Advertisement
Starting a dishwashing cycle
1. Check that the spray arms can turn freely.
2. Turn the water tap on fully.
3. Press the ON/OFF button.
4. Use the direction buttons (
The name of the selected rinsing cycle will flash. The predicted duration of the
cycle is displayed to the right of the cycle name.
5. Press the OK/START button.
A light signal in the form of a dot appears at floor level.
If the dishwasher is built in at high level with flush fitting cupboard doors, the
light signal cannot be seen.
The dot shaped light signal is not dangerous. (It is not a laser.) It lights up while
a dishwasher cycle is running and goes out when the cycle ends.
In the text display you will see the name of the current stage of the cycle. Beside
this you will see the predicted time remaining in minutes.
The OPTION button allows you to briefly view the name of the rinsing cycle in
the display.
A rinsing cycle can only be started from the cycle menu.
During the rinsing cycle, the remaining time shown on the display is adjusted
according to the size of the load, degree of soiling, etc.
You cannot make changes to the options or settings while a rinsing cycle is in
progress.
Interrupting or aborting a dishwashing cycle
Only interrupt a dishwashing cycle that is in progress if it is absolutely necessary.
Interrupting the dishwashing programme by opening the dishwasher door
Hot steam may escape when the door is opened. There is a risk of scalding.
1. Open the door carefully. The dishwashing cycle will stop, in the display: PLEASE
CLOSE DOOR
2. Close the door. The cycle will continue.
or
) to select the cycle required.
29
In daily use
Advertisement
Table of Contents
