Table of Contents
Advertisement
4. A c c e s s or ie s
Unloading the Stacker Tray
4- 1 2
Use the following procedure to unload the HCS Stacker Tray when
it is full, or you want to retrieve a job that has been completed.
1.
Press the Unload button on the HCS Control Panel. The
Wait light blinks until the HCS Stacker Tray has reached the
down position.
2.
Open the front door when the Unload Light illuminates.
3.
Position the securing bar on top of the stacked paper.
4.
Pull the HCS Stacker Cart straight out.
5.
Remove the securing bar.
6.
Remove the paper from the HCS Stacker Tray.
7.
Push the empty Stacker Cart straight into the HCS.
8.
Position the securing bar on the fixed area inside the HCS.
NOTE: The front door will not close if the securing bar is not
properly attached to the HCS frame.
9.
Close the HCS front door.
10.
Follow the instructions displayed on the digital press UI to
resume printing.
Do c uC o lo r 50 0 0A P Us e r G ui d e
Advertisement
Table of Contents
