Problem
Fault Code 112-130
Jam indicated in
stacker/stapler, but is
also in Exit Module.
Fault Code 112-130
Jam indicated in
stacker/stapler.
Fault Code 112-110
Fault Code 052-310
Fault Code 052-321
Fault Code 052-320
Fault Code 052-312
Ready Indicator does
not illuminate
Do c u Co lo r 50 0 0A P U s e r G u i de
Cause
Paper is jammed over
both the Exit Module and
stacker/stapler sensors.
Paper is jammed
between the
Exit Module and the
stacker/stapler sensors.
Paper jammed in the
stacker/stapler and the
Exit Module during a
purge of sheets to the
Top Tray.
Communication problem
Connection problem
Unexpected connection
Communication problem
No power
Solution
•
Open the stacker/stapler door.
•
Clear any visible jams.
•
If no jammed paper is visible in the stacker/stapler
area indicated, open the Exit Module door and
clear any jammed paper. Close the Exit Module
door.
•
Open and close the stacker/stapler door.
•
Open the stacker/stapler door.
•
If no jammed paper is visible in the area indicated,
open the Exit Module door and clear any jammed
paper. Close the Exit Module door.
•
Open and close the stacker/stapler door.
•
If the fault persists, undock the stacker/stapler and
clear the jammed paper between the Exit Module
and the stacker/stapler. Refer to the Note below
this table for information on how to undock the
stacker/stapler.
•
Clear the jammed paper from the stacker/stapler.
•
Clear the jammed paper from the Exit Module.
•
Open and close the stacker/stapler door.
•
Resume job.
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and
power on.
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and
power on.
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and
power on.
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and
power on.
•
Check the power cord connected to the power
source.
•
Check that the main switch is on.
4. A c c es s o r i e s
4-31