4. A c c e s s or ie s
Problem
Poor Stacking:
Paper Jams:
4- 3 2
Cause
Mixed sizes of paper
High paper curl
Mechanical obstruction
Use Top Tray
High paper curl
NOTE: To undock the stacker/stapler from the digital press, reach
into the circular area near the bottom of the stacker/stapler for the
Undocking Lever. Refer to the picture below.
Pull the lever toward you and hold it in position while moving the
stacker/stapler a small distance (25.4mm, 1in.) away from the
press. Release the lever and continue to move the stacker/stapler
as far as required.
Solution
Run separate jobs and empty stacker.
•
Adjust digital press Decurler. See,
Profile" on page 2-5
for additional information.
•
Flip paper in digital press paper tray(s).
•
Rotate paper in the digital press paper tray(s).
•
Check for obstruction in the stacker stapler paper
path.
•
Ensure that all transports and baffles are properly
seated.
Deselect offset or restart job to the Top Tray.
•
Adjust digital press Decurler. See,
Profile" on page 2-5
for additional information.
•
Flip paper in digital press paper tray(s).
•
Rotate paper in the digital press paper tray(s).
•
Switch to heavier paper.
Location of Undocking Lever
Do c uC o lo r 50 0 0A P Us e r G ui d e
"Decurler
"Decurler