Table of Contents
Advertisement
You can configure your Prestige to receive calls from remote dial-in users, e.g.,
telecommuters, as well as remote nodes. There are several differences between dial-in users
and remote nodes, as summarized in the table below.
Table 6-1 Remote Dial-in Users/Remote Nodes Comparison Chart
Remote Dial-in Users
Your Prestige will only answer calls from remote
dial-in users; it will not make calls to them.
All remote dial-in users share one common set of
parameters, as defined in the Default Dial In Setup
(Menu 13).
This chapter discusses how to setup default dial-in parameters for both remote node and
remote dial-in users. The following sections give two examples of how your Prestige can be
configured as a dial-in server.
Dial-In Server Configuration
Prestige 100 and 100IH ISDN Router and Router/Hub
Dial-in Server Configuration
Remote Nodes
Your Prestige can make calls to and receive calls
from the remote node.
Each remote node can have its own set of
parameters such as Bandwidth On Demand.
Chapter 6
6-1
Advertisement
Table of Contents
Troubleshooting
