Control Installation - Casablanca Vita Owner's Manual

AdvAn•TOUCH
w-63 Bracket / holster reMoval
Step 1. Remove the two 6-32 x
5/16" screws holding the bracket
to the holster. Set aside screws
for later.
SaFEty FiRSt: to reduce the risk of electrical shock, this fan must be installed with an isolating wall
warNING: To reduce the risk of fire or electric shock, do not use this fan with any solid state speed
control device. use only the control provided with this fan.
Standard light Switch
Step a. Remove the two screws holding the switch cover
plate. do not remove the cover plate.
Step B. orient the control bracket as shown and line up
the two inner mounting holes with those on the switch.
Step C. Insert and tighten the screws using the provided
screwdriver.
Wall Installation
Step A. locate a 2x4
wall stud in a convenient
location.
Step B. orient the control
bracket as shown over
the 2x4 stud.
Step C. Insert the 1" wood
screws in either the inner
or outer mounting holes
and tighten using the
provided screwdriver.
attachMent of holster to Bracket
Step 2.
After you have completed installing the bracket to the wall, using the two screws removed in Step 1, attach the
W-63 holster to the bracket.
12
®

control installation

control Bracket installation
control/switch. Caution! do not use with wall dimmer.
Rocker light Switch
Step a. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch
cover plate. do not remove the cover plate.
Step C. orient the control bracket as shown and line
up the two inner mounting holes with those on the
switch.
Step d. Insert and tighten the screws using the provided
screwdriver.
notE: the wall anchors and 6-32 x 1" screws may
be used in situations where mounting to a stud is not
possible. use the inner mounting holes. After securing
the anchor, discard the anchor's pointed screws and
use the 6-32 decor ovalhead screws supplied.
ANCHOR
PANHEAD
SCREW
1" WOOD SCREW
DRYWALL ANCHOR
6-32 x 1" DECOR
OVERHEAD SCREW