Table of Contents
Advertisement
Prime •ToUcH
Prime•ToUcH2™ Hardware (not to scale)
w-505
w-505
control Bracket
control
SaFEtY FiRSt: to reduce the risk of electrical shock, this fan must be installed with
an isolating wall control/switch. CAUTIOn! Do not use with wall dimmer.
Step 10. Follow instructions below for the type of
transmitter control you will be installing.
Standard toggle light Switch
a. Remove the two screws holding the switch cover plate.
do not remove the cover plate.
b. orient the control bracket as shown and line up the two
inner mounting holes with those on the switch.
c. install and tighten screws using the provided
screwdriver.
CAUTIOn! Do not use with wall dimmer.
WARnInG! To reduce the risk of fire or electric
shock, do not use this fan with any solid state speed
control device. Use only the control provided with
this fan.
Wall Installation
a. locate a 2 x 4 wall stud in a convenient -location.
b. orient the control bracket as shown over the 2x4 stud.
c. use the 1-inch wood screws in the inner mounting
holes. insert and tighten the screws using the provided
screwdriver.
notE: The wall anchors and 6-32 x 1" screws may be
used in situations where mounting to a stud is not possible.
use the inner mounting holes. after securing the anchor,
discard the anchor's pointed screws and use the supplied
6-32 decor ovalhead screws.
This device complies with RSS-210 of Industry
Canada. Operation is subject to the following
two conditions: (1) This device may not cause
interference, and (2) This device must accept any
interference, including interference that may
cause undesired operation of the device.
10
conTRol InSTallaTIon
®
12v Battery
conTRol BRackeT InSTallaTIon
drywall anchor
6-32 (2)
NOTICE: Changes or modifications not expressly
approved in writing by Casablanca Fan Company
may void the user's authority to operate this
equipment.
wood
Screw
Screw
6-32 x
/
3
8
1" (2)
(2)
"
Hide quick links:
Advertisement
Table of Contents
