Table of Contents
Advertisement
PrIME•TOUCH ® W-505 CONTrOl INSTallaTION
haRdWaRe (not to scale)
W-505
ContRoL
(tRanSMitteR)
CONTrOl BraCKET INSTallaTION
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed
with an isolating wall control/switch. CAUTION! Do not use with wall dimmer.
Standard toggle Light Switch
a.
Remove the two screws holding the switch cover
plate. do not remove the cover plate.
b. Orient the control bracket as shown and line up
the two inner mounting holes with those on the
switch.
c. insert screws and tighten using the provided
screwdriver.
Caution! do not use with wall dimmer or
rocker switch.
WaRning! to reduce the risk of fire or
electric shock, do not use this fan with any
solid state speed control device. use only
the control provided with this fan.
Wall installation
a. locate a 2 x 4 wall stud in a convenient location.
b. Orient the control bracket as shown over the 2x4
stud.
c. use the one-inch wood screws in the inner mounting
holes. insert and tighten the screws using the
provided screwdriver.
nOTe: The wall anchors and 6-32 x 1" screws may
be used in situations where mounting to a stud is not
possible. use the inner mounting holes. after securing
the anchor, discard the anchor's pointed screws and
use the supplied 6-32 decor ovalhead screws.
NOTICE: Changes or modifications not
expressly approved in writing by Casablanca
Fan Company may void the user's authority
to operate this equipment.
W-505
ContRoL
BRaCKet
P
RIME•
Wood SCReWS,
12v BatteRY
dRYWaLL anChoRS,
6-32 (2)
MountinG
hoLeS
ContRoL
BRaCKet
MountinG
hoLeS
ContRoL
BRaCKet
this device complies with RSS-210 of
industry Canada. operation is subject to the
following two conditions: (1) this device may
not cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
T
®
OUCH
SCReWS,
6-32 X
3
/8" (2)
1" (2)
SCReWS,
6-32 X 1"(2)
StandaRd
toGGLe
SWitCh
SWitCh
CoveR
PLate
13
Advertisement
Table of Contents
