Changing Transmitter Frequency Setting - Casablanca Vita Owner's Manual

Pressing the SECuRItY button will start the Security lighting
program. the controller beeps and indicates "SECuRItY." the
light will automatically turn on and oFF in a seemingly random
manner over an eight and 8¼-hour programmed cycle that is
designed to give the home a "lived-in" look.
Regardless of the light setting when switching to the Security
mode (lights on or off, dim or bright), the lights will increase to
high brightness and then begin the Security cycle. this cycle
is then repeated continuously until cancelled by pressing the
SECuRItY button.
At any time during Security mode, you can adjust the fan speed,
reverse the direction, operate in Auto Speed or Winter mode, use
Saver, or run the test mode without affecting Security mode.
You may still turn the light on and oFF (or oFF and on) manually
for temporary lighting, but the light will continue to operate
automatically at its programmed times.
the Home-Safe Program makes an unoccupied home
appear occupied by turning the lights on and off at random
times.
to enter the Home-Safe Program:
1. turn the PoWER off for at least three seconds.
2. turn the PoWER on.
3. Immediately operate the buttons in the following sequence:
4. A tone and flashing light indicate this command has been
accepted.
note: All fans leave the factory set to "10000."
You will have to change the dip switch settings in the remote
if you are using more than one fan in the same area and want
to control them separately.
Step 1. At the circuit breaker or fusebox, turn the power off
for the fan you want to change.
Step 2. Open the battery door of the Advan•Touch control
and remove the first battery on the left to gain access to the
dip switches.
Step 3. Change the dip switch settings, assuring that they are
different from the previously installed Advan•Touch fan(s).
Step 4. Re-install the battery in the proper polarity and the
battery door on the control.
Step 5. At the circuit breaker or fuse box, turn the power back
on for the fan whose frequency you are changing.
Step 6. Within 20 seconds of restoring power, push the up
and down buttons at the same time. Hold for a few seconds.
You will see the LCd screen flash all of the graphics. You will
now have control of the fan.
note: You may want to label your controls to ensure you do
not mix them up.
securitY feature
hoMe-safe
chanGinG frequencY settinG
A
DVAN
SECURITY MODE CYCLE
1. On for 60 minutes (80% bright)
2. Off for 30 minutes
3. On for 120 minutes (30% bright)
®
proGraM
this program overrides all manual control of lights and fan.
the lights will now be automatically cycled on and off in a
controlled sequence as follows: on 1 hour, off 1/2 hour, on
2 hours, off 1 hour, on 1/2 hour then off 2 hours.
this seven hour pattern will repeat continuously so that a
different pattern of lighting is seen each day of the week.
to cancel the Home-Safe Program, turn the PoWER off for
three seconds.
DIP SWITCH
LOCATION
•T
OUCH®
4. Off for 60 minutes
5. On for 90 minutes (50% bright)
6. Off for 60 minutes
15