W-74 Wall Control Preparation; W-74 Control Installation; Installing The W-74 Wall Control; Single W-74 Installation - Casablanca Ceiling Fans Owner's Manual

Ceiling fans

Hide thumbs Also See for Ceiling Fans:

Installation manual (12 pages)

Table of Contents

W-74

Wall Control

WARNING! To avoid possible electrical shock,

make certain that electricity is turned off at the

circuit breaker or fuse box before attempting any

installation or repair procedure

CAUTION! NOT turning the power OFF at the circuit breaker

or fuse box may cause damage to the electronics within the

wall control and or the PC board on the fan�

NOTE: W-74 Wall Control should only be installed on Casablanca's Direct-Touch

The wall control installs in the same manner as an ordinary light switch, using an existing wall box and

wiring� This controller is designed to signal the fan microcomputer as well as perform normal switching

operations� For this reason the following precautions must be observed:

1� Use only the Casablanca W-74 wall control�

2� Do not use any additional control with your

Direct-Touch

fan (for example, dimmer, or fan

speed control)�

Ensure power is turned OFF at the breaker or fuse panel before starting installation.

If you have multiple Direct-Touch

section "changing frequency setting" on page 20�

Remove the screws and switch plate from the existing

switch box�

Remove the screws holding the switch in the switch

box�

Pull the existing switch from the switch box to expose

the wire connections�

Remove the two wires from the switch�

Connect the BLACK wire from the POWER SOURCE

that you just removed from the switch to the BLACK/

WHITE STRIP wire on the W-74 wall control� Secure

this connection with a wire nut�

Connect the second BLACK wire that you just removed

from the switch to the second BLACK wire on the

located on the back of the W-74 wall control� Secure

this connection with a wire nut�