Settings Page - GE Legend IP User Manual

50 Legend IP
User Manual
Canceling the mask returns you to the first mask-programming screen, where you
reposition the camera view. Saving the mask size saves the mask at the set size and returns
you to the Privacy Masks page.
Clear. The Clear button deletes the mask that is currently selected.

Settings page

The features on Page1 and Page2 of the Settings page allow you to customize the dome's performance for
advanced applications.
Page1 tab
To access the Page1 page of Settings, select Camera, Settings, and Page1.
Figure 39. Page1 page
Note: Remember to select OK to save any changes you make on the page.
Day/Night. Day/Night is a camera feature that switches the camera mode from color (day) to
monochrome (night) and removes the IR cut filter, which increases the camera's sensitivity in low
light. It also allows the camera to function with IR lighting. Choices are Auto (default), Manual, and
Off.
• Auto: Enables the camera to automatically switch between day (color) and night (monochrome)
modes at a factory default light level. The factory default is not changeable. You can briefly
override the day/night setting from a GE KTD-405 or 404 keypad. Within a few seconds, the dome
will return to the mode (day or night) determined by the Auto setting.
Note: If the Day/Night feature's Auto setting switches between color and monochrome eight times within a
minute, the Auto setting will be disabled for 30 minutes. After 30 minutes, the Auto setting will be enabled,
if it is still programmed. Manual control of the Day/Night feature is available while the Auto setting is
disabled.