GE Legend IP User Manual page 134

126 LegendIP
User Manual
4. Access the Advanced Streaming Configuration page (Figure 82) by selecting Advanced setup. Verify
the IP address of the Legend IP in the Streaming Address field. Also make sure the Streaming Port is
set to 8090, and both Sender and Receiver Control ports are set to 8092. Mark the checkboxes for both
control ports.
Figure 82. Streaming configuration - advanced
The SymNet should now be setup for receiving video streams from the Legend IP device.
5. Access the GUI of the Legend IP device using an analog monitor and serial keypad, or through the web
based interface.
6. Navigate to Camera | Encoder | Video to setup the encoding resolution (Figure 83). We recommend
setting Variable bit rate to Off, and Latency to Low latency.
Figure 83. Legend IP encoder settings