Using The Graphical Keyboard; Inactivity Timer - GE Legend IP User Manual

Table of Contents

Using the graphical keyboard

The programming interface has an internal graphical keyboard for entering passcodes, network data, and

custom titles. Open the graphical keyboard (Figure 20) by selecting the icon

necessary characters, select Done on the keyboard or press the set (

Then select OK to save the changes made to the page. Pressing esc on the keypad while you are still in the

keyboard erases the characters shown. You must select OK or Cancel to save or cancel the changes entered on

the page.

Figure 20. Using the keyboard of the programming interface

The programming interface has a 10-minute keypad inactivity timer. When being used with keypads that do not

have their own inactivity timer, the programming interface will time out after 10 minutes of inactivity. When

being used with keypads that do have their own inactivity timer and it is less than the 10-minute timer of the

programming interface, the programming interface will time out when the keypad does. When being used with

keypads that have a longer inactivity timer, the programming interface will time out after 10 minutes of

inactivity. Refer to your keypad's manual to see if it has an inactivity timer and what the duration is so that you

know when you can expect the programming interface to time out.

Select the OK icon to save

changes to the page.

. After you have entered the

) key on the keypad to return to the page.

Select the ab icon to

open the keyboard.

Select the Done icon to

close the keyboard.

Chapter 3

Programming tools

Table of Contents