Passcode Page - GE Legend IP User Manual

To access the Memory page, select Setup and Memory.
Figure 26. Memory page
CAUTION: Clearing memory replaces your custom programmed settings with the factory default settings.
Select memory. You can clear all or specific portions of your dome's programming, which is saved in the
housing's memory. After selecting a setting, select Clear. Choices are Clear all (default), Clear setup
options, Clear presets, Clear macros, Clear ShadowTours, Clear areas, Clear alarm actions, and
Clear privacy masks.
Note: Clear all clears all settings, except passcodes, installation date, IP address and subnet mask.

Passcode page

You can control who has access to the features of your dome by distributing passcodes that allow varying
degrees of access. The dome ships with no default passcodes. When you enter the programming interface for
the first time during installation and go to Setup | Passcode, the passcode fields are blank. Blank passcode
fields mean the passcodes are turned off (disabled). You can choose to enter passcodes into the blanks. This
turns passcodes on (enabled) and a passcode will be required to enter the programming interface the next time
you access it.
CAUTION: If you use passcodes, record them in a secure place. If you forget the passcodes for a dome, you will need to
send the dome back to the factory so that it can be reset with no passcodes.
If no passcodes are programmed, all users are given installer access and are not required to log on. If only the
Admin and Operator passcodes are programmed, then anyone can still access the entire programming interface
as an installer, since the Installer passcode is not programmed.
Chapter 5
Advanced programming
35