Presets; Programming Presets From The Keypad; Programming Presets With The Programming Interface; Keypad - GE Legend IP User Manual

Presets

You can set presets from the keypad or with the graphical programming interface. If you set your presets
from the keypad, you may want to go into the programming interface to customize them with titles and
exposure settings. Programming presets with the KTD-400 or KTD-404 must be done using the Legend IP on-
screen programming interface.
There are a total of 127 presets (1 through 127) that you can define for your dome.
The dome also provides the ability to remap any preset or tour command to activate any of the 127 presets, 16
tours, or 32 macro actions. This enables you to manually initiate any of the expanded capabilities of the dome
from keypad controllers with limited command capability. See
Note: Most keypads have a limited number of preset numbers they can call. If you have a GE KTD-405 keypad with firmware
v1.2.09 or later, and it is operating with Impac RS-485 protocol, then you can call up all 127 preset numbers (1 through
127) directly from the keypad. If, however, you have a GE KTD-405 keypad with an earlier version of firmware, or it is
operating with Digiplex RS-422 protocol, then you can use the keypad to call up only the first 63 preset numbers
(1 through 63). If you are using presets 62 and 63 for your left and right autopan limits, then you have a total of 125 or 61
preset numbers that you can call up from the keypad. To verify your keypad's version, press and hold the mon key on
the keypad, until the keypad beeps, then press the >> key.

Programming presets from the keypad

To program presets from the KTD-405 keypad, do the following:
1. Use the joystick to pan, tilt, and zoom the camera to the desired view.
2. Press store on the keypad.
3. Press the number keys on the keypad that correspond to the preset number you want to assign for this
position.
4. Press store again.
Note: If the keypad does not allow you to program a desired preset, you may need to change the lowest user-
definable preset in the keypad program menus. Refer to the keypad manual.
5. After programming your presets, you can verify them, one at a time, by pressing the find key on the
keypad and then pressing the number keys that correspond to each preset. If you are not satisfied with
any views, you can reprogram those preset positions starting with step 1 above.
6. If desired, go into the programming interface to customize the preset with a title and exposure settings.
See Presets page

Programming presets with the programming interface

To program presets with the programming interface, do the following:
1. Access the programming interface. See
2. Select Actions by guiding the joystick to move the cursor over the Actions menu and twisting the
joystick knob.
on page 59.
Accessing the programming interface
Command Map page on page 85.
Chapter 4
Basic programming
on page 9.
29