GE Legend IP User Manual page 135

7. Access the control tab of the Encoder menu (Figure 84). Ensure that the port numbers match the
SymNet and that the checkboxes are marked. The Streaming address should be the same as the
destination SymNet device. The mode must be Sender to initiate point-to-point streaming. The Control
Port is not used in this mode.
Figure 84. Legend IP encoder control settings
8. Video should now begin streaming between devices. This sometimes requires an initial reset of one or
both devices, and it can take up to 30 seconds to begin streaming the first time it is initiated, but once
set, both devices will attempt to maintain this stream across resets and power cycles.
127