Hot-Swap Sas/Sata Backplane - Intel SR1500 - AXXMINIDIMM DDR-2 RAID Controller Cache Memory Manual

5BPeripheral and Hard Drive Sub-System
6.4.3.5 Optional Hardware RAID Support
The active mid-plane supports options to provide full hardware RAID support. Options required
to enable hardware RAID support include an Intel
AXXRAK18E) and installation of a Mini-DIMM for Intel RAID Cache support. To protect from
data loss during an unexpected power loss event, an Intel
(AXXRSBBU3) is also supported. Hardware RAID levels supported include 0, 1, 5, 10, and 50.
®
6.4.3.5.1 Intel RAID Activation Key
®
The Intel RAID Activation Key enables the full intelligent SAS Hardware RAID solution
engineered around the Intel
in to a connector (J1A10) on the mid-plane board. With no RAID activation key installed, only
SAS Software RAID levels 0, 1, and 10 are supported.
6.4.3.5.2 Intel RAID Cache support
To further enable support for hardware RAID, the active mid-plane provides a 244-pin mini-
DIMM connector (J8C1), supporting a single registered ECC non-parity DDR2-400 MHz Mini-
DIMM to provide Intel RAID cache. Mini-DIMM capacities supported range from 128MB to 1GB.
®
Note: See the Intel Server Board S5000PAL Tested Memory List for a list of Intel validated
mini-DIMMs.
®
6.4.3.5.3 Intel RAID Smart Battery Backup Module
®
With an Intel RAID Smart Battery Backup module installed, data loss is prevented when data is
still present in the RAID Cache Module and power is unexpectedly lost. Depending on the cache
module capacity used, the battery backup unit can provide 48 to 72 hours of battery backup
power to allow data stored in the RAID cache to be processed. A 2x10 connector (J9A2) is used
to attach the battery backup unit to the mid-plane. See Table 24. Active Mid-plane SAS RAID
Battery Backup Connector Pin-out for details.
6.5

Hot-Swap SAS/SATA Backplane

The chassis supports a multifunctional SAS/SATA backplane with the following features:
•
Vitesse* VSC410 enclosure management controller
o External non-volatile Flash ROM
2
o Four I C interfaces
o Compliance with SCSI Accessed Fault Tolerant Enclosures (SAF-TE)
specification
o Compliance with Intelligent Platform Management Interface (IPMI)
•
Five SAS/SATA compatible hot-swap hard drive connectors
•
Designed to support an optional 6
•
Hard Drive Status and Fault LEDs for each hard drive connector
52
®
®
80333 I/O Processor @ 500MHz. The activation key plugs directly
th
hard drive, or power for an optional tape drive.
Intel order number D31980-009
Intel® Server System SR2500AL
RAID Activation Key (product order code -
®
RAID Smart Battery Backup module
Revision – 1.6