Using The Manual Feeder For Copying - Oce 9600 User Manual

Using the manual feeder for copying

If you want to copy a job on a media type and/or size that is not available on
one of the paper rolls or cassette trays, it is more convenient to manually feed
sheets instead of switching paper rolls or cassette trays. The sheet feed is a
special slot just above the roll drawers on the engine. You can insert pre-cut
copy material in this slot, one sheet at a time.
Only use media as specified in '' on page 287.
Note:
Copying on pre-cut sheets
Open the 'Sheet' card in the 'Copy' section.
1
Press the 'Manual feed' button. The display will look as follows:
2
[22] Using the manual feed option
Select any other required settings.
3
Enter the number of copies using the numeric buttons.
4
Feed in the original.
5
Press the start button.
6
Take your sheet of copy material to the side of the printer engine that contains
7
the sheet feed.
Use both hands to align the copy material in accordance with the format
8
indication and the sticker on the manual feed table.
Move the copy material forward onto the tip of the roller. This should cause an
9
ample paper bulge over the full width of the page.
Hold the paper with both hands until the engine pulls in the first part of the
10
sheet.
The bulge will be reduced or disappear. A few seconds later, the complete sheet
will be pulled into the printer.
If the copy job requires more sheets, the display will ask you to feed
Note:
in the next sheet.
Repeat steps 7 to 11 to complete the job.
11
Collect your output.
12
54 Océ 9600 Copier/Printer User Manual