Connecting The Scanner To Your Computer Or To Another Scsi Device - Epson FILMSCAN 200 User Manual

Connecting the scanner to your computer or to
another SCSI device
Follow the steps below to connect the EPSON FilmScan 200
(SCSI interface model) to your computer or another device.
Note:
The combination of 50-pin and 25-pin connectors you need may vary
depending on the maker of your SCSI device and SCSI interface board.
1. Make sure that the scanner, the computer, and all other SCSI
devices are turned off and unplugged from any power
source.
c
Caution:
Do not connect the scanner to the computer or other
devices while they are turned on; otherwise damage may
occur.
2. Connect one end of the SCSI cable to the scanner's SCSI
connector; then squeeze the wire clips together until they
lock in place, or tighten the screws on the sides of the
connector.
Connecting EPSON FilmScan 200 to Your Computer
An example using the scanner's 50-pin interface.
2
2-9