Electrical standard:
ID Setting:
Terminator:
Connector type:
Connector pin arrangement:
25
50 pin
50
13
25 pin
25
Initialization Methods
The scanner can be initialized (returned to a fixed set of conditions) in the
following ways:
Hardware initialization
Software initialization
A-8
Appendix
ANSI X3.131-1986
Selectable from 0 to 7
(SCSI ID number for the EPSON FilmScan
200 is originally set to 2.)
Internal terminator selectable
(enable/disable)
D-SUB 25-pin and Centronics 50-pin
connectors
*
The scanner is turned on.
*
The scanner receives an INIT signal from the
parallel interface: pin 31 goes LOW.
*
The scanner receives a SCSI Reset signal
from the SCSI interface.
* The RESET button is pressed.
*
Software sends the ESC @ (initialize the
scanner) command.
*
The scanner receives a SCSI Bus Device
Message.
1
26
1
14