Connecting The Scanner Using The Scsi Interface - Epson Expression 1680 Setup Manual

Connecting the Scanner Using the SCSI
Interface
For instructions on connecting the scanner to your computer
using the SCSI interface, read this section.
Note for Macintosh
You need to install the scanner software before connecting the scanner
to your computer. Follow the instructions in Chapter 3 to install your
software, then connect your scanner as described in this chapter.
For PC users:
Unless your PC already has a SCSI board installed, you need to
install one, along with SCSI driver software. Install the SCSI board
according to the directions included with it. Also see "Installing
a SCSI interface board" on page 2-8.
Note:
You will also need to install the SCSI driver that is normally included
with Windows (see your Windows documentation for instructions), or
the driver described in your SCSI board installation documentation.
If your PC has a SCSI board up and running, connect the scanner
as described in "Connecting the scanner" on page 2-13.
For Macintosh users:
Your Macintosh may or may not have SCSI ports, depending on
which model you own. See the next section if you need to install
a SCSI board in your Macintosh. If your Macintosh already has a
SCSI port, install the scanner software as described in Chapter 3,
then connect the scanner to your Macintosh as described in
"Connecting the scanner" on page 2-13.
Note:
The latest driver may be available for download from the Web site of the
SCSI board manufacturer.
®
users:
Setting Up the Scanner
2
2-7