Epson FILMSCAN 200 User Manual page 119

EPSON TWAIN is not
selected properly.
Your scanner port is not
properly selected in the
EPSON Scanner Setup
dialog box in Windows.
The interface board is not
installed properly.
For EPSON FilmScan 200
(Parallel model) users:
The I/O port address of the
parallel interface board is
already taken by another
device.
For EPSON FilmScan 200
(parallel model) users:
The interface board is not
compatible with your scanner.
7-12
Troubleshooting
From your application's File menu, click
Select Source (or a similar command)
and make sure that EPSON Scanners
for Windows 3.1x, EPSON Scanners
(32-bit) for Windows 95/NT, or
EPSON FilmScan 200 for Macintosh is
selected. See "Capturing Images Using
EPSON TWAIN" in Chapter 4 (for 35
mm film) or Chapter 5 (for cartridge
film).
If you have installed another TWAIN
driver besides EPSON TWAIN, you
need to choose the port for EPSON
FilmScan 200 in the EPSON Scanner
Setup dialog box. To choose the port,
open the EPSON Scanner Setup dialog
box from the Control Panel; then
choose the port for your scanner. For
more details, see "Installing the
Scanner Software in Your PC" in
Chapter 3.
Check that the board is installed
correctly and securely. See the user's
guide that comes with the interface
board.
Change the I/O port address to an
unused value. See your computer and
parallel interface user's guides. Write
down the I/O port address, as you
will need to specify it when making
the port settings in the EPSON
Scanner Setup dialog box.
Install the EPSON bidirectional
interface board that came with your
scanner. See the interface board's
documentation for instructions.