Power-On Sequence - Epson FILMSCAN 200 User Manual

Note:
To connect the scanner to a SCSI device other than the
computer, the length of cable in the daisy chain must be
6 meters or less; otherwise the system may not work properly.
To connect the scanner to a PC using SCSI-2, the length of
the cable must be 3 meters or less.
3. Connect the other end of the cable to the SCSI port of your
computer or another SCSI device.
4. Connect the power cables of your computer, scanner, and
other external SCSI devices to a power supply.
Note:
Before turning on your system, be sure to read "Power-on sequence"
below.

Power-on sequence

Keep the following in mind every time you turn your computer
and SCSI devices on.
If you have an internal hard disk, turn on the scanner and
any other SCSI devices you plan to use. Wait about 30
seconds; then turn on your computer. Otherwise the
computer may not work properly.
If you have an external hard disk, turn on the scanner,
external hard disk (which should be first on the daisy
chain), and any other SCSI devices you plan to use. Wait
around 30 seconds; then turn on the computer.
You do not have to turn on unused SCSI devices even if
they are in the middle of the daisy chain.
2-10
Connecting EPSON FilmScan 200 to Your Computer