Checking Initialization; Connecting The Scanner To Your Computer; Connecting The Scanner Using The Scsi Interface - Epson 1680 Manual

Checking initialization

Before connecting the scanner to your computer, follow the steps below to make sure
that the scanner initializes, or starts up, properly.
1. Open the document cover so you can see the operation of the scanner during
initialization.
2. Turn on the scanner by pressing the
3. Make sure the fluorescent lamp on the carriage and the READY light flash, and the
carriage moves slightly.
4. When the READY light stops flashing and stays on, it means the scanner has
completed initialization.
5. Turn off the scanner.
If the scanner does not work as described, make sure the power cord is firmly plugged
c
in and that you have released the transportation lock, then try again.
Caution:
Whenever you turn off the scanner, wait at least 10 seconds before turning
it back on. Rapidly turning the scanner on and off can damage it.

Connecting the Scanner to Your Computer

Connecting the scanner using the SCSI interface

For instructions on connecting the scanner to your computer using the SCSI interface,
read this section.
Note for Macintosh® users:
You need to install the scanner software before connecting the scanner to your
computer. Follow the instructions in Chapter 3 of the online Setup Guide to install your
software, then connect your scanner as described here.
14
P
operate button.