Epson FILMSCAN 200 User Manual page 120

For EPSON FilmScan 200
(parallel model) users:
The I/O port address of the
parallel interface board does
not match the port address in
EPSON TWAIN.
For EPSON FilmScan 200
(SCSI model) users:
The computer was turned
on before the scanner.
For EPSON FilmScan 200
(SCSI model) users:
The SCSI driver is not
installed properly.
For EPSON FilmScan 200
(SCSI model) users:
The scanner's SCSI ID
conflicts with the ID for
another device.
For EPSON FilmScan 200
(SCSI model) users:
The SCSI chain is not
correctly terminated.
Check the I/O port address of the
interface board, and change the I/O
port address setting in the EPSON
Scanner Setup dialog box to match the
address of the interface board. See
page 3-6 for information on port ID
settings.
Note:
Even if the EPSON parallel interface
board that came with your scanner is
installed, you will need to change the I/O
port address if you have changed its
jumper setting. Write down the I/O port
address, as you will need to specify it when
making the port setting in the EPSON
Scanner Setup dialog box.
Turn off the scanner and your computer.
Turn on the scanner; then turn on your
computer. See "Power-on sequence" in
Chapter 2.
Install the driver properly. See the
SCSI board user's guide. Then check
the board's operation using the utility
software that came with the board.
Change the SCSI ID number to an
unused number as described in "SCSI
connections" on page 2-5. Use your
SCSI board's utility software to check
the ID numbers of other connected
SCSI devices.
Check the connection sequence and set
the termination as described in "SCSI
connections" on page 2-5.
Troubleshooting
7
7-13