Creating An Nqa Test Group; Configuring An Nqa Test Group; Configuring Icmp Echo Tests - HP 6125G Configuration Manual

Step
1. Enter system view.
2. Enable the NQA client.

Creating an NQA test group

Create an NQA test group before you configure NQA tests.
To create an NQA test group:
Step
1. Enter system view.
2. Create an NQA test
group, and enter the
NQA test group view.

Configuring an NQA test group

Configuring ICMP echo tests

ICMP echo tests of an NQA test group uses ICMP echo response information to test reachability of a
destination host. An ICMP echo test has the same function as the ping command but provides more
output information. In addition, you can specify the next hop for ICMP echo tests. ICMP echo tests are
used to locate connectivity problems in a network.
NQA ICMP echo tests are not supported in IPv6 networks. To test the reachability of an IPv6 address, use
the ping ipv6 command. For more information about the command, see Network Management and
Monitoring Command Reference.
To configure ICMP echo tests:
Step
1. Enter system view.
2. Enter NQA test group view.
3. Configure the test type as
ICMP echo, and enter test
type view.
4. Configure the destination
address of ICMP echo
requests.
5. Configure the size of the data
field in each ICMP echo
request.
Command
system-view
nqa agent enable
Command
system-view
nqa entry admin-name
operation-tag
Command
system-view
nqa entry admin-name
operation-tag
type icmp-echo
destination ip ip-address
data-size size
101
Remarks
N/A
Optional.
Enabled by default.
Remarks
N/A
In the NQA test group view, you can specify the test
type.
You can use the nqa entry command to enter the test
type view of an NQA test group with test type
configured.
Remarks
N/A
N/A
N/A
By default, no destination IP address is
configured.
Optional.
100 bytes by default.