HP 6125G Configuration Manual page 95
Network management and monitoring configuration guide
Hide thumbs
Also See for 6125G:
- Command reference manual (426 pages) ,
- Configuration manual (379 pages) ,
- Release note (60 pages)
Table of Contents
Advertisement
[DeviceA-GigabitEthernet1/0/2] quit
Configure Device B (the intermediate device):
2.
# Create VLAN 2 as the remote probe VLAN.
<DeviceB> system-view
[DeviceB] vlan 2
# Disable MAC address learning for the remote probe VLAN.
[DeviceB-vlan2] mac-address mac-learning disable
[DeviceB-vlan2] quit
# Configure GigabitEthernet 1/0/1 as a trunk port that permits the packets of VLAN 2 to pass
through.
[DeviceB] interface GigabitEthernet 1/0/1
[DeviceB-GigabitEthernet1/0/1] port link-type trunk
[DeviceB-GigabitEthernet1/0/1] port trunk permit vlan 2
[DeviceB-GigabitEthernet1/0/1] quit
# Configure GigabitEthernet 1/0/2 as a trunk port that permits the packets of VLAN 2 to pass
through.
[DeviceB-GigabitEthernet1/0/1] quit
[DeviceB] interface GigabitEthernet 1/0/2
[DeviceB-GigabitEthernet1/0/2] port link-type trunk
[DeviceB-GigabitEthernet1/0/2] port trunk permit vlan 2
[DeviceB-GigabitEthernet1/0/2] quit
Configure Device C (the destination device):
3.
# Configure GigabitEthernet 1/0/1 as a trunk port that permits the packets of VLAN 2 to pass
through.
<DeviceC> system-view
[DeviceC] interface GigabitEthernet 1/0/1
[DeviceC-GigabitEthernet1/0/1] port link-type trunk
[DeviceC-GigabitEthernet1/0/1] port trunk permit vlan 2
[DeviceC-GigabitEthernet1/0/1] quit
# Create a remote destination group.
[DeviceC] mirroring-group 1 remote-destination
# Create VLAN 2 as the remote probe VLAN.
[DeviceC] vlan 2
# Disable MAC address learning for the remote probe VLAN.
[DeviceC-vlan2] mac-address mac-learning disable
[DeviceC-vlan2] quit
# Configure VLAN 2 as the remote probe VLAN of the mirroring group and GigabitEthernet
1/0/2 as the monitor port of the mirroring group, disable the spanning tree feature on
GigabitEthernet 1/0/2, and assign the port to VLAN 2.
[DeviceC] mirroring-group 1 remote-probe vlan 2
[DeviceC] interface GigabitEthernet 1/0/2
[DeviceC-GigabitEthernet1/0/2] mirroring-group 1 monitor-port
[DeviceC-GigabitEthernet1/0/2] undo stp enable
[DeviceC-GigabitEthernet1/0/2] port access vlan 2
[DeviceC-GigabitEthernet1/0/2] quit
Verify the configurations.
4.
88
Advertisement
Table of Contents
