Information Center Configuration Task List; Outputting System Information To The Console; Configuring A System Information Output Rule For The Console - HP 6125G Configuration Manual

IP address of the log sender
•
content
This field provides the content of the system information.

Information center configuration task list

Task

Outputting system information to the console

Outputting system information to the monitor terminal
Outputting system information to a log host
Outputting system information to the trap buffer
Outputting system information to the log buffer
Outputting system information to the SNMP module
Outputting system information to the Web interface
Configuring synchronous information output
Disabling an interface from generating link up/down logging information
Outputting system information to the console
This section describes how to output system information to the console.

Configuring a system information output rule for the console

Step
1. Enter system view.
2. Enable the information
center.
3. Name the channel with a
specified channel
number.
4. Configure the channel
through which system
information can be
output to the console.
5. Configure an output rule
for the console.
Command
system-view
info-center enable
info-center channel channel-number
name channel-name
info-center console channel
{ channel-number | channel-name }
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap { level
severity | state state } * ] *
40
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
N/A
Optional.
Enabled by default.
Optional.
See Table 2 for default channel names.
Optional.
By default, system information is output
to the console through channel 0
(known as console).
Optional.
See "Default output rules of system
information."