Outputting System Information To The Trap Buffer - HP 6125G Configuration Manual

Step
5. Specify the source IP
address for the log
information.
6. Configure the format of
the time stamp for system
information output to the
log host.
Set the format of the
7.
system information sent
to a log host to
UNICOM.
8. Specify a log host and
configure the related
output parameters.

Outputting system information to the trap buffer

The trap buffer only receives trap information, and discards log and debug information.
To output system information to the trap buffer:
Step
1. Enter system view.
2. Enable the information
center.
3. Name the channel with a
specified channel number.
4. Configure the channel
through which system
information can be output
to the trap buffer and
specify the buffer size.
5. Configure a system
information output rule for
the trap buffer.
Command
info-center loghost source
interface-type interface-number
info-center timestamp loghost { date |
iso | no-year-date | none }
info-center format unicom
info-center loghost [ vpn-instance
vpn-instance-name ]
{ host-ipv4-address | ipv6
host-ipv6-address } [ port
port-number ] [ dscp dscp-value ]
[ channel { channel-number |
channel-name } | facility
local-number ] *
Command
system-view
info-center enable
info-center channel channel-number
name channel-name
info-center trapbuffer [ channel
{ channel-number | channel-name } |
size buffersize ] *
info-center source { module-name |
default } channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap { level
severity | state state } * ] *
43
Remarks
Optional.
By default, the source IP address of
output log information is the primary
IP address of the matching route's
egress interface.
Optional.
date by default.
Optional.
HP by default.
By default, no log host is specified. If
you specify to output system
information to a log host, the system
uses channel 2 (loghost) by default.
The value of the port-number
argument should be the same as the
value configured on the log host
Otherwise, the log host cannot
receive system information.
Remarks
N/A
Optional.
Enabled by default.
Optional.
See Table 2 for default channel
names.
Optional.
By default, system information is
output to the trap buffer through
channel 3 (known as trapbuffer)
and the default buffer size is 256.
Optional.
See "Default output rules of system
information."