Configuring The Rmon Alarm Function - HP 6125G Configuration Manual

You can configure multiple history control entries for one interface, but must make sure their entry
•
numbers and sampling intervals are different.
The device supports up to 100 history control entries.
•
You can successfully create a history control entry, even if the specified bucket size exceeds the
•
history table size supported by the device. However, the effective bucket size will be the actual value
supported by the device.
To configure the RMON history statistics function:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Create an entry in the
RMON history control
table.

Configuring the RMON alarm function

Follow these guidelines when you configure the RMON alarm function:
To send traps to the NMS when an alarm is triggered, configure the SNMP agent as described in
•
"Configuring SNMP" before configuring the RMON alarm function.
• If the alarm variable is a MIB variable defined in the history group or the Ethernet statistics group,
make sure the RMON Ethernet statistics function or the RMON history statistics function is
configured on the monitored Ethernet interface. Otherwise, even if you can create the alarm entry,
no alarm event can be triggered.
You cannot create a new event, alarm, or private alarm entry that has the same set of parameters
•
as an existing entry. For parameters to be compared for duplication, see
After the maximum number of entries is reached, no new entry can be created. For the table entry
•
limits, see
To configure the RMON alarm function:
Step
1. Enter system view.
2. Create an event entry in
the event table.
Command
system-view
interface interface-type
interface-number
rmon history entry-number buckets
number interval sampling-interval
[ owner text ]
Table 7.
Command
system-view
rmon event entry-number [ description string ] { log |
log-trap log-trapcommunity | none | trap
trap-community } [ owner text ]
69
Remarks
N/A
N/A
N/A
Table 7.
Remarks
N/A
N/A