Ntp Message Format - HP 6125G Configuration Manual

Prior to system clock synchronization between Device A and Device B, the clock of Device A is set
•
to 10:00:00 am while that of Device B is set to 1 1:00:00 am.
Device B is used as the NTP time server, so Device A synchronizes to Device B.
•
It takes 1 second for an NTP message to travel from one device to the other.
•
Figure 5 Basic workflow of NTP
The synchronization process is as follows:
• Device A sends Device B an NTP message, which is timestamped when it leaves Device A. The
timestamp is 10:00:00 am (T1).
When this NTP message arrives at Device B, it is timestamped by Device B. The timestamp is
•
1 1:00:01 am (T2).
When the NTP message leaves Device B, Device B timestamps it. The timestamp is 1 1:00:02 am
•
(T3).
When Device A receives the NTP message, the local time of Device A is 10:00:03 am (T4).
•
Up to now, Device A can calculate the following parameters based on the timestamps:
The roundtrip delay of NTP message: Delay = (T4–T1) – (T3-T2) = 2 seconds.
•
Time difference between Device A and Device B: Offset = ((T2-T1) + (T3-T4))/2 = 1 hour.
•
Based on these parameters, Device A can synchronize its own clock to the clock of Device B.
This is a rough description of how NTP works. For more information, see RFC 1305.

NTP message format

NTP uses two types of messages: clock synchronization and NTP control messages. All NTP messages
mentioned in this document refer to NTP clock synchronization messages. NTP control messages are
10