Display Schedule Job - HP 6125G Command Reference Manual

If no IRF member switch is specified, the system displays the mode of the last reboot of the master.
Examples
# Display the mode of the last reboot of IRF member switch 1.
<Sysname> display reboot-type slot 1
The rebooting type this time is: Cold
The output shows that the mode of the last reboot of member switch 1 is Cold boot (cold boot will restart
a device by powering it on). (The display of Warm represents a warm boot, which means to restart a
device by using the commands like reboot).

display schedule job

Syntax
display schedule job [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display schedule job to display the job configured by using the schedule job command.
Related commands: schedule job.
Examples
# Display the job configured by using the schedule job command.
<Sysname> display schedule job
Specified command: execute 1.bat
Specified view: system view
Executed time: at 12:00 10/31/2010 (in 0 hours and 16 minutes)
If you change the system time within 16 minutes after you execute the schedule job command, the
scheduled task becomes invalid. Then, if you execute the display schedule job command again, the
system displays nothing.
Table 24 Command output
Field
Specified command
Specified view
Description
Command to be executed
View for the command to be executed
144