Telnet Client Dscp - HP 6125G Command Reference Manual

View
User view
Default level
0: Visit level
Parameters
remote-host: IPv4 address or host name of a remote host, a case-insensitive string of 1 to 20 characters.
service-port: TCP port number of the Telnet service on the remote host. It is in the range of 0 to 65535 and
defaults to 23.
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN that the remote system belongs to, where
vpn-instance-name is a case-sensitive string of 1 to 31 characters.
source: Specifies the source interface or source IPv4 address of Telnet packets.
interface interface-type interface-number: Specifies the source interface. The source IPv4 address of the
Telnet packets sent is the IPv4 address of the specified interface. interface-type interface-number
represents the interface type and number.
ip ip-address: Specifies the source IPv4 address of Telnet packets.
Description
Use telnet to Telnet to a remote host.
To terminate the current Telnet connection, press Ctrl+K or use the quit command.
The source IPv4 address or source interface specified by this command is applicable to the current Telnet
connection only.
Examples
# Telnet to the remote host 1.1.1.2, specifying the source IP address of Telnet packets as 1.1.1.1.
<Sysname> telnet 1.1.1.2 source ip 1.1.1.1

telnet client dscp

Syntax
telnet client dscp dscp-value
undo telnet client dscp
View
System view
Default level
2: System level
Parameters
dscp-value: Specifies a DSCP value in the range of 0 to 63.
Description
Use telnet client dscp to set the DSCP value for IPv4 to use for outgoing Telnet packets on a Telnet client.
Use undo telnet client dscp to restore the default.
By default, IPv4 uses the DSCP value 16 for outgoing Telnet packets on a Telnet client.
44