Table of Contents
Advertisement
www.netcommlimited.com
5.2.6
Advanced Routing
This page allows you to configure static and dynamic routing rules for your Smart Hub.
The Smart Hub's Advanced Routing Settings can be viewed and configured by selecting the "Advanced Routing"
menu item under the "Internet Settings" tab in the Advanced View of the Management Console.
5.2.6.1
Advanced Routing – Static
Static Routing allows computers that are connected to your Smart Hub to communicate with computers on
another LAN segment which are connected to it via another router. To set a rule, you need to specify the following:
ƒ
Destination
ƒ
Subnet mask
ƒ
Gateway
Interface
ƒ
5.2.6.2
Advanced Routing – Dynamic
Dynamic Routing uses the RIP protocol to allow the Smart Hub to adapt to changes in the network. RIP enables
the device to determine the best route for each packet based on the "hop count" or number of hops between
Source and Destination. To enable Dynamic Routing, select Enable from the drop box and click Apply.
5.2.7
DHCP Client List
This page allows you to view the current DHCP clients that have obtained IP leases from your Smart Hub. The
MAC address, assigned IP address and the expiry period is shown for all computers who have automatically
obtained addresses from the Smart Hub. Please note that this list is stored in the device's volatile memory, and is
therefore cleared if the device is reset or if any changes are applied to configuration.
The Smart Hub's DHCP Client list can be viewed by selecting the "DHCP clients" menu item under the "Internet
Settings" tab in the Advanced View of the Management Console.
Telus smart Hub
3G8WV-TS
25
Advertisement
Table of Contents
