Configuring An Aggregate Interface; Configuring The Description Of An Aggregate Interface - 3Com 4500G Family Configuration Manual

To do...
Create a Layer 2 aggregate
interface and enter the Layer 2
aggregate interface view
Configure the aggregation
group to work in dynamic
aggregation mode
Exit to system view
Enter Layer 2 Ethernet
interface view
Assign the Ethernet interface to
the aggregation group
Assign the port a LACP priority

Configuring an Aggregate Interface

You can perform the following configurations on an aggregate interface:

Configuring the Description of an Aggregate Interface

Enabling Link State Trapping for an Aggregate Interface
Shutting Down an Aggregate Interface
Configuring the Description of an Aggregate Interface
You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
Follow these steps to configure the description of an aggregate interface:
To do...
Enter system view
Enter aggregate interface
view
Configure the description of
the aggregate interface
Use the command...
interface bridge-aggregation
interface-number
link-aggregation mode
dynamic
quit
interface interface-type
interface-number
port link-aggregation group
number
lacp port-priority port-priority
Use the command...
system-view
interface bridge-aggregation
interface-number
description text
1-11
Remarks
Required
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
Required
By default, an aggregation
group works in static
aggregation mode.
—
Required
Repeat these two steps to
assign multiple Layer 2
Ethernet interfaces to the
aggregation group.
Optional
By default, the LACP priority of
a port is 32768.
Changing the LACP priority of a
port may affect the aggregation
state of the ports in the dynamic
aggregation group.
Remarks
—
—
Optional
By default, the description of an
interface is interface-name
Interface, such as
Bridge-Aggregation1
Interface.