Troubleshooting Route Policy Configuration; Ipv4 Routing Information Filtering Failure - 3Com 4500G Family Configuration Manual

[SwitchA] ipv6 route-static 20:: 32 11::2
[SwitchA] ipv6 route-static 30:: 32 11::2
[SwitchA] ipv6 route-static 40:: 32 11::2
# Configure a route policy.
[SwitchA] ip ipv6-prefix a index 10 permit 30:: 32
[SwitchA] route-policy static2ripng deny node 0
[SwitchA-route-policy] if-match ipv6 address prefix-list a
[SwitchA-route-policy] quit
[SwitchA] route-policy static2ripng permit node 10
[SwitchA-route-policy] quit
# Enable RIPng and apply the route policy to static route redistribution.
[SwitchA] ripng
[SwitchA-ripng-1] import-route static route-policy static2ripng
2) Configure Switch B.
# Configure the IPv6 address for VLAN-interface 100.
[SwitchB] ipv6
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ipv6 address 10::2 32
# Enable RIPng on VLAN-interface 100.
[SwitchB-Vlan-interface100] ripng 1 enable
[SwitchB-Vlan-interface100] quit
# Enable RIPng.
[SwitchB] ripng
# Display RIPng routing table information.
[SwitchB-ripng-1] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::7D58:0:CA03:1
Dest 10::/32,
via FE80::7D58:0:CA03:1, cost
Dest 20::/32,
via FE80::7D58:0:CA03:1, cost
Dest 40::/32,
via FE80::7D58:0:CA03:1, cost

Troubleshooting Route Policy Configuration

IPv4 Routing Information Filtering Failure

Symptom
Filtering routing information failed, while the routing protocol runs normally.
on Vlan-interface 100
1, tag 0, A, 18 Sec
1, tag 0, A, 8 Sec
1, tag 0, A, 3 Sec
1-10