Displaying And Maintaining Gvrp - 3Com 4500G Family Configuration Manual

To do...
Enter
Ethernet
interface
view, Layer
2 aggregate
interface
view, or
port-group
view
Configure the Hold timer
Configure the Join timer
Configure the Leave timer
As shown in Table
If you want to set a value beyond the value range for a timer, you may change the value range by
tuning the value of another related timer.
If you want to restore the default settings of the timers, restore the Hold timer first, and then the Join,
Leave, and LeaveAll timers.
Table 1-2 Dependencies of GARP timers
Timer
Hold 10 centiseconds
No less than two times the Hold timer
Join
setting
Greater than two times the Join timer
Leave
setting
LeaveAll Greater than the Leave timer setting

Displaying and Maintaining GVRP

To do...
Display statistics about GARP
Display GARP timers for specified
or all ports
Display the local VLAN information
maintained by GVRP
Enter Ethernet or
Layer 2 interface interface-type
aggregate interface-number
interface view
Enter port-group
port-group manual
view port-group-name
garp timer hold timer-value
garp timer join timer-value
garp timer leave timer-value
1-2, the values of GARP timers are dependent on each other:
Lower limit
display garp statistics [ interface
interface-list ]
display garp timer [ interface
interface-list ]
display gvrp local-vlan interface
interface-type interface-number
Use the command...
No greater than half of the Join timer
setting
Less than half of the leave timer setting
Less than the LeaveAll timer setting
32765 centiseconds
Use the command...
1-6
Remarks
Required
Perform either of the
commands.
Depending on the view you
accessed, the subsequent
configuration takes effect on a
port or all ports in a
port-group.
Optional
10 centiseconds by default.
Optional
20 centiseconds by default.
Optional
60 centiseconds by default.
Upper limit
Remarks
Available in any view
Available in any view
Available in any view