Installing Twain Data Source - Fujitsu TWAIN 32 Manual

3.3 Installing TWAIN Data Source

1. Confirm that the mini-port driver has been installed by following the procedure
given in Section 3.2.
2. Insert the Installation CD into the disk drive. Here, the CD-ROM drive is
temporarily labeled "D:". (If the current operating environment uses a
different label, replace the drive label specifications below accordingly.)
3. Using Explorer, locate the "install.exe" file in the "D:\Driver2\Setup" folder of
the CD-ROM drive. Then, to start installation, either double-click the file icon,
or click the icon and press the [Enter] key.
If automatic start has been defined, the start screen of the setup is displayed.
Installation can also be started from this screen.
4. The installation screen is displayed. To continue the installation process,
follow the instructions on the screen.
•
Select the language to be used for installation.
•
In the [Select Components] dialog box, select the check boxes of the
components to be installed. Simple explanations related to the selected
components are displayed in the box at the bottom.
•
Check the installation destination directory. To change the installation
destination, click the [Directory Change...] button, and type in the installation
destination directory.
•
Click the [Continue] button to start installation.
5. Confirm that the following group has been created when the setup is
complete. The icons displayed in the window depend on the components
selected in [Select Components] during installation.
Figure: Fujitsu TWAIN group
48
BACK TO MAIN PAGE